Lýsing
Treat yourself to the best. The Epix+ series stands out from the crowd with a proprietary, sporty design, developed with today’s modern vehicles in mind. EPIX5+ Strobe is an additional light/work light with selectable yellow/orange position light and approved R65 flash light that ensures your visibility. The unique position light is fully integrated into the reflector.
The EPIX5+ Strobe is a small ramp (barely 13 cm wide) that gives a modern look and has the performance to meet all situations. With its 30 W, this ramp provides a light with a range of 225 m. EPIX5+ Strobe is approved as additional light according to ECE R112. With 1700 actual lumens and a color temperature of 5000K, it provides strong and natural lighting that facilitates in all conditions. Self-developed smart mounts ensure mounting pretty much wherever and however you want on the vehicle.
Position light
The ramp has the Epix series specially designed reflectors which are fully integrated into the reflector. The color of the position light can be selected between yellow/orange and white.
Flash light
Epix5+ Strobe is equipped with 10 different flash light patterns, one of which is ECE R65 approved. By simply connecting two units together, you can get both synchronous and asynchronous flash patterns between them. Use your Epix5+ Work Strobe LED ramp as a work light or extra light; the strobe turns off when turned on and then starts with your previously selected flash pattern immediately when you turn the lighting off again.
What else is needed?
- DT relay kit: Ledson Connect provides a super easy connection while being interconnectable if there is a future desire to easily expand with additional lights or ramps
- If you want to reduce the energy consumption of your Epix Series ramp, you can easily install ourE-screw. By mounting this screw on the back of the ramp, it is put into eco mode, the brightness is lowered and energy consumption is reduced.
Characteristics and technical data:
- Position light with unique dynamic ignition, integrated in the reflector
- E-marked ECE R149 (R112), R7, R65 and R10 (EMC rated)
- Selectable position light in white or yellow/orange
- Driving Beam (wide and oblong light)
- Range: 225 m (1 lux)
- 2450 lumens (theoretical), 1700 lumens (actual)
- Color temperature 5000K (Neutral white)
- 30 W (2 x 15 W LEDs)
- Voltage: 9-36V
- IP69K (water/dustproof)
- Aluminum housing and polycarbonate lens
- Side reflective optics
- Pressure equalization membrane
- Electronic heat management
- DT connector (supplied)
- 1.8 at 12V and 0.9 at 24V
Included:
- EPIX5+ Strobe LED Ramp
- Bolts and screws to attach the ramp to the appropriate surface
- Mounting details for gable mounting
- Mounting details for rear mounting, standing/hanging
- DT connector 6-pin
Dimensions (excl. brackets):
- Width: 128 mm
- Height: 43 mm
- Depth: 61 mm
Flash light pattern
- Single flash synchronized: 2.2 Hz
- Single flash asynchronous: 2.2 Hz (when using 2 ramps)
- Triple flash synchronized: 1.1 Hz
- Triple flash asynchronous: 1.1 Hz (when using 2 ramps)
- Quadruple flash synchronized: 1.25 Hz
- Quadruple flash asynchronous: 1.25 Hz (when using 2 ramps)
- Combination (one long and five short) synchronized: 0.83 Hz
- Combination (one long and five short) asynchronous: 0.83 Hz (when using 2 ramps)
- Flash burst synchronized: 10 Hz
- Flash series asynchronous: 10 Hz (when using 2 ramps)
NOTE: The DT connector must not be cut as this means an increased risk of moisture damage and the warranty then ceases to apply.
